Horn Switch: Service and Repair

WARNING: BEFORE BEGINNING ANY AIRBAG SYSTEM REMOVAL OR INSTALLATION PROCEDURES, REMOVE AND ISOLATE THE BATTERY NEGATIVE CABLE FROM THE VEHICLE BATTERY. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO DO THIS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL
The Horn Switch is an integral part of the Driver Airbag Module and if defective, the Driver Airbag Module must replaced.

Negative Battery Cable Remote Terminal:

1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove the two speed control switch screws from the steering wheel back cover.
3. Remove the two speed control switches and disconnect the wires.
4. Remove the two bolts retaining the Driver Air- bag Module.
5. Lift the module and disconnect the airbag horn wire connectors.
6. Remove the Driver Airbag Module from the vehicle.

INSTALLATION
For installation, reverse the above procedures. Assure that the switch is locked into position. Use caution not to pinch wires.