Receiver Dryer: Service and Repair

CAUTION: When installing new filter/drier do not leave open to atmosphere for a long period of time. The filter/drier contains moisture absorbing materials which will absorb moisture in the atmosphere.

REMOVAL
1. Remove refrigerant from A/C system using a refrigerant recovery machine.
2. Remove one 8mm hex bolt to filter/drier bracket.
3. Remove one nut retaining A/C lines to expansion valve.
4. Gently pry filter/drier bracket out of strut tower.
5. Remove one A/C line at filter/drier (tubing to condenser).
6. Remove filter/drier from vehicle.
7. Transfer small line from filter/drier to expansion valve to new filter/drier.

NOTE: Always install new O-rings when replacing filter/drier.

8. Plug or cap liquid line fittings while system is open to prevent moisture intrusion.

INSTALLATION
For installation, reverse the above procedures.

NOTE: Upon installation, loosely fit all parts and lines together before individually tightening them to prevent damage. Torque filter/drier plumbing fasteners to 10 ft-lbs.