Cruise Control Servo: Service and Repair

REMOVAL
1. Disconnect the negative battery cable.
2. Remove three bolts from servo bracket.
3. Disconnect electrical connectors and vacuum hose.
4. Remove two nuts attaching speed control cable and mounting bracket to servo.
5. Remove servo mounting bracket.
6. Pull cable away from servo to expose retaining clip and remove clip attaching cable to servo.

INSTALLATION
1. With throttle in full open position align hole in speed control cable sleeve with hole in servo pin and install retaining clip.
2. Connect vacuum hose to servo.
3. Connect electrical connector.
4. Insert servo studs through holes in speed control cable and mounting bracket.
5. Install nuts, tighten to 6.7 N.m (60 in. lbs.).
6. Install servo and bracket and tighten bolt and nuts.
7. Connect negative battery cable.