Instrument Panel Center Bezel

REMOVAL

Negative Battery Cable Remote Terminal:

1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove ash receiver (if applicable).
3. Using a trim stick (special tool #C-4755), gently pry out on center trim bezel. Disconnect wiring connectors to HVAC controls, cigar lighter/auxiliary power outlet and traction control switch.
4. Remove instrument panel center trim bezel.

NOTE: The traction control switch, HVAC control head and cigar lighter/auxiliary power outlet must be transferred to new bezel if being replaced.

INSTALLATION
For installation, reverse the above procedures