Visual Inspection and Service

CAUTION: Do not allow baking soda solution to enter vent holes, as damage to battery can result.

Cleaning Battery:

1. Clean battery with a solution of warm water and baking soda. Apply solution with a bristle brush and allow to soak until acid deposits loosen. Rinse with clear water and blot dry with paper toweling. Dispose of toweling in a safe manner. Refer to the WARNINGS on top of battery.
2. Inspect battery case and cover for cracks or leakage. If leakage is present battery must be replaced.
3. Inspect battery tray for damage caused by acid from battery. If acid damage is present, it will be necessary to clean area with:
- Baking soda solution
- Wire brush
- Scraper
4. Clean battery terminals with baking soda and suitable cleaning tool.
5. Inspect cables for damage and broken terminals. Replace damaged, frayed cables and broken terminal.
6. Inspect battery for proper or damaged hold down ledge.