Antenna: Service and Repair

REMOVAL

Battery Negative Remote Cable:

1. Disconnect and isolate the battery negative remote cable.
2. Inside trunk, pull the right side trunk liner aside.
3. Unplug antenna lead from base of antenna body.
4. Remove antenna mast by unscrewing mast from antenna body. Use tape (electrical) to prevent scratching of the mast.

Antenna Mounting Removal:

5. Remove cap nut and adapter.
6. Pull antenna body down through the quarter panel and remove.

INSTALLATION
For installation, reverse the above procedures. Check that the locating tab is in-line with the slot in the body before installing antenna. Tighten cap nut to 7 N.m (65 in. lbs).