FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.
Home >> Chrysler >> 1999 >> Sebring Convertible L4-2.4L VIN X >> Repair and Diagnosis >> Transmission and Drivetrain >> Relays and Modules - Transmission and Drivetrain >> Relays and Modules - A/T >> Control Module >> Service and Repair

Control Module: Service and Repair

Do not interchange transmission control modules with previous year transmission control modules. If a same year Transmission Control Module (TCM) is being used from a different vehicle, the following procedures must be performed:
- Quick Learn Procedure
- Electronic Pinion Procedure
The transmission control module is next to the battery on the left side of vehicle, in the engine compartment. It is held in place by three mounting screws.

NOTE: If the transmission control module has been replaced, the following procedures must be performed:

- Quick Learn Procedure: This procedure will allow the transmission control module to learn the characteristics of the vehicle.
- Electronic Pinion Factor Procedure: This procedure will reprogram the TCM to compensate for different tire sizes and final drive ratios.

REMOVAL
1. Disconnect battery negative cable at the left strut tower.
2. Remove air cleaner clamps and air cleaner.
3. Remove Transmission Control Module (TCM) 60 way connector.
4. Remove three mounting screws.

Fig. 39:





5. Remove TCM (Fig. 39).


INSTALLATION
1. For installation, reverse removal procedure.
pro multis Credits:Operation CHARM About Operation CHARM