Horn Switch: Service and Repair

WARNING: BEFORE BEGINNING ANY AIRBAG SYSTEM REMOVAL OR INSTALLATION PROCEDURES, REMOVE AND ISOLATE THE BATTERY NEGATIVE CABLE FROM THE VEHICLE BATTERY. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO DO THIS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL
1. Disconnect and isolate battery negative cable in engine compartment.
2. Remove the screws that attach the Driver Airbag Module to the steering wheel.
3. Lift the module to gain access and disconnect the squib wire.
4. Place Driver Airbag Module on a clean level surface with pad facing upward.
5. If the contact area is bad, replace Driver Airbag Module. If the mounting bracket or bushings are bad, replace steering wheel.

INSTALLATION
For installation, reverse the above procedures. Use caution not to pinch wires.