Brake Lamp: Service and Repair

REMOVAL
1. Release decklid latch and open decklid.
2. Remove trunk lining as necessary to gain access to tail lamp nuts.
3. Remove plastic nuts attaching tail lamp to rear closure panel.

Tail/Stop, Turn Signal, Backup And Side Marker Lamp:

4. Remove lamp from opening in quarter panel.
5. Rotate bulb sockets counterclockwise one quarter turn.
6. Pull bulb sockets from back of lamp.
7. Remove tail, stop, turn signal, backup and side marker lamps from vehicle.

INSTALLATION
1. Position tail, stop, turn signal, backup and side marker lamp to vehicle.
2. Push bulb sockets into back of lamp.
3. Rotate bulb sockets clockwise one quarter turn.
4. Position lamp to opening in quarter panel.
5. Install plastic nuts to attach tail lamp to rear closure panel in the following sequence: outboard, center, inboard.
6. Install trunk lining.