Verification Test VER-1A - Body
BODY VERIFICATION TEST VER-1A1. Reconnect all previously disconnected components and connectors.
2. If the Sentry Key Immoblizer Module was replaced, obtain the vehicle's unique pin number in Step 9. If no replaement was made, continue to next step.
3. If the Body Control Module was replaced, you must turn the ignition On for 15 secs (to learn VIN) or engine will not start. Use the DRB and program all RKE transmitters used with the vehicle.
4. Use the DRB and recalibrate HVAC doors.
5. Use the DRB and program other options as necessary. If the vehicle is equipped with VTSS, select MISCELLANEOUS and ENABLE VTSS.
6. If any repairs were made to the HVAC system or the Battery was disconnected: Start the engine and, using the DRB, recalibrate the HVAC doors.
7. Ensure that the ignition is ON, and with the DRB, erase all Diagnostic Trouble Codes.
8. Turn the ignition OFF and wait 5 seconds.
9. Turn the ignition ON and fully operate the system that was malfunctioning. If the system is operating properly, continue to the next step. If not operating properly, select and perform the appropriate test from the Symptom List.
10. With the DRB, read Body Control Module Trouble Codes. If no trouble codes are present and customer's complaint cannot be duplicated, the repair is compete. If any codes are present, return to the Symptom List and follow the path specified for that trouble code.
11. Obtain the vehicle's unique PIN number assigned to it's original SKIM module from either the vehicle's invoice number or from Chrysler's Customer Center.
12. With the DRB, select THEFT ALARM, SKIM, MISCELLANEOUS. Select SKIM Module Replaced function and the DRB will prompt you through the following steps.
13. Enter secured access mode using the unique 4 digit PIN number.
14. Program the vehicle's VIN number into the SKIM's memory.
15. Program the country code into the SKIM's memory (US).
16. Transfer the vehicle's unique Secret Key data from the PCM. This process will require the SKIM module to be in secured access mode. The PIN number must be entered into the DRB before the SKIM will enter secured access mode.
17. Once secured access mode is active, the SKIM will remain in that mode for 60 seconds.
18. Program all customer keys into the SKIM's memory. This requires that the SKIM be in secured access mode. The SKIM module will immediatly exit secured access mode after each key is programmed.
19. Note: Secured access mode is not required to query the programmed status of the key.
20. Note: If the PCM is replaced, the unique Secret Key data must be transferred from the SKIM module to the PCM. This procedure requires the SKIM to be placed in secured access mode using the 4 digit PIN code.
21. Note: If three attempts are made to enter secured access mode using an incorrect PIN, secured access mode will be locked out for one hour. To exit this locked out mode, turn the ignition to the RUN position for one hour.
22. Ensure all accessories are turned OFF. Also monitor the battery state and connect a battery charger if necessary.
23. To program Sentry Keys using the Customer Programming method, which requires two valid smart keys, refer to either the owner's manual or service manual.
24. Turn the ignition ON, then wait 3 minutes. With the DRB, read the SKIM trouble codes.
25. If no codes are present, the system is operational and the repair is complete. If codes are present, select the appropriate test from the Symptom List.