General Information

IN-VEHICLE SERVICE
The following components are serviceable in the vehicle without transaxle removal:
- Valve Body Assembly
- Solenoid Pack
- Transmission Range Sensor (TRS)
- Input Speed Sensor
- Output Speed Sensor
- Transfer Chain
- Chain Sprockets
- Short (right) Stub Shaft Seal
- Long (left) Stub Shaft and Ball Bearing
Refer to Removal and Installation for applicable procedures.

FLUID REQUIREMENTS

NOTE: Refer to Service Procedures for fluid level checking procedures.

TRANSMISSION
Mopar ATF+4 (Automatic Transmission Fluid Type 9602) is required in this transaxle (transmission side only). Substitute fluids can induce torque converter clutch shudder.

DIFFERENTIAL
The differential side of the transaxle should be filled with MOPAR Fuel Saving 75W-90 hypoid gear lubricant. Synthetic gear lubricants should be avoided.

FLUID ADDITIVES
Other than fluorescent leak detection dye, the use of any fluid additives (transmission or differential) is not recommended in this transaxle.