Heater-A/C Controls

REMOVAL

Negative Battery Cable Remote - Terminal:

1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Remove the ash receiver assembly, if necessary. Refer to Body and Frame/ Interior Trim/ Ash Tray/ Service and Repair. Service and Repair

Instrument Panel Center Trim Panel Removal:

Heater - A/C Control Head Removal:

3. Remove the instrument panel center trim bezel and remove the two electrical connectors from the back of the control head and traction control switch (if equipped). Instrument Panel Center Trim Bezel
4. From the back of the center trim bezel, remove the six retaining screws from the heater - a/c control head and remove from the bezel.

INSTALLATION
For installation, reverse the above procedures