Programming By Customer

For a customer to be able to program RKE transmitters themselves, at least one RKE transmitter must be programmed already. This procedure is to add additional transmitters. If all transmitters are lost, the DRB III must be used to program the new transmitters.

Transmitter programming by the customer is done by continually pressing the UNLOCK button, on a programmed fob, for a minimum of 4 seconds to a maximum of 10 seconds with the ignition switch ON. Within the 4-10 second range, the PANIC button is depressed. Both buttons are then released.

The BCM will chime. Then press any button on each fob to be programmed. The BCM will chime as each fob is learned. To exit program mode, turn OFF ignition or wait 32 seconds. The BCM will chime again.