Instrument Panel Upper Cover

REMOVAL
1. Using a trim stick (special tool #C-4755), pry out the left and right a-pillar moldings, slide rearward and remove.
2. Using a trim stick, pry out the left and right a-pillar moldings, slip each end of the top cover disengaging clips. Refer to Body and Frame/ Interior Trim/ Service and Repair. A-Pillar Trim Moldings
3. Lift rear edge of the top cover using a trim stick along the rear edge of the top cover.
4. Slide top cover rearward to disengaging the eight clips.
5. Remove the upper cover from vehicle.

INSTALLATION
For installation, reverse the above procedures