Wheel Cylinder Removal and Installation

Rear Drum Brake Components Removal:

REMOVAL
1. Loosening the parking brake cable adjusting nut.
2. Drain the brake fluid.





3. Follow the removal steps outlined in the image.
4. Use a flat-tipped screwdriver or the like to open up the retainer joint, and remove the retainer.

INSTALLATION
1. Follow removal steps in reverse order for installation, noting the following.





2. Install the washer in the direction shown above.





3. Use pliers or the like to install the retainer on the pin.
4. Fill the master cylinder with brake fluid conforming to DOT 3 or DOT 4 standards.
5. Bleed the brake system.
6. Perform parking brake lever stroke adjustment check.