Power Steering Pump Flow Control Valve Seal Replacement

DISASSEMBLE
The power steering pump does not require removal from the engine for removal and replacement of the flow control valve fitting O-Ring.

Fig. 2:

1. Remove the power steering fluid pressure hose from power steering pump pressure fitting.





2. Remove the power steering pump discharge/flow control valve fitting from the power steering pump housing. Use care to prevent the flow control valve and the spring from sliding out of the discharge/flow control valve fitting.
3. Remove and discard O-ring seal from fitting.

ASSEMBLE
1. If necessary, clean and install flow control valve and spring in pump housing bore.
2. Install new O-ring seal on fitting.
3. Install the discharge/flow control valve fitting into the power steering pump. Tighten the discharge/flow control valve to a torque of 75 Nm (55 ft. lbs.).
4. Install power steering fluid pressure hose on flow control valve fitting. Tighten the banjo bolt to a torque of 34 Nm (25 ft. lbs.).