Verification Test VER-1A - No Start Verification Test

IMPORTANT NOTE: If the Powertrain Control Module (PCM) has been changed and the correct VIN and mileage have not been programmed, a Diagnostic Trouble Code 9DTC) will be set in the ABS and Air bag modules. In addition, if the vehicle is equipped with a Smart Key Immobilizer Module (SKIM), Secret Key data must be updated to enable starting.

For ABS and Air Bag systems:

ACTION:
1. Enter correct VIN and Mileage in PCM.
2. Erase codes in ABS and Air Bag modules.

For SKIM theft alarm:

ACTION:
1. Connect the DRB to the data link connector.
2. Go to Engine, Misc. and place the SKIM in secured access mode, by using the appropriate PIN code for this vehicle.
3. Select Update the Secret Key data, data will be transferred from the SKIM to the PCM.

Inspect the vehicle to ensure that all engine components are connected. Reassemble and reconnect components as necessary.

Inspect the engine for contamination. If it is contaminated, change the oil and filter.

Attempt to start the engine.

If the engine is unable to start, look for any Technical Service Bulletins that may relate to this condition. Return to DTC TEST if necessary.

The repair is now compete.