PROM - Programmable Read Only Memory: Technical Service Bulletins

• Recalls
  • Recall - Reprogram the PCM
    • Overview
    • Service Procedure
      • Overview
      • A. Reprogram the PCM
      • B. Install Authorized Software Update Label
      • C. Install the Authorized Modifications Label
      • D. Complete Proof of Correction Form For California Residents
    • Owner Letter
• Customer Interest
  • I/M Testing - OBDII CARB Readiness Monitor Information
    • Overview
    • Repair Procedure
  • Heater - Poor Performance/Slow Engine Warm Up
    • Overview
    • Repair Procedure
      • Overview
      • Reprogramming Procedure
  • A/T - 4th to 3rd Gear Coast Down Shift Point
  • PCM - Vapor Lock Condition
  • PCM - Incorrect Misfire Condition/Flashing MIL
  • PCM - No Engine Restart/Rough Idle After Hot Soak
    • Overview
    • Repair Procedure
      • Overview
      • 2.7L Thermostat and Heater Supply Hose Modification (Revised)
  • PCM - No Engine Restart/Rough Idle After a Hot Soak.
  • Powertrain Control Module - Multiple Concerns
• All Technical Service Bulletins
  • Engine Controls - Flash Programming Failure Recovery
    • Overview
    • Connected/Disconnected Flash Mode Using TechCONNECT
    • Pay Attention While Performing Flash Reprogram Procedures
    • Error Messages
    • Enhanced and Original Abort Recovery
    • Enhanced Abort Recovery Screens
    • Original Abort Recovery Screen
    • Programmable Modules
    • Powertrain Modules - Engine and Transmission
  • I/M Testing - OBDII CARB Readiness Monitor Information
    • Overview
    • Repair Procedure
  • Heater - Poor Performance/Slow Engine Warm Up
    • Overview
    • Repair Procedure
      • Overview
      • Reprogramming Procedure
  • A/T - 4th to 3rd Gear Coast Down Shift Point
  • PCM - Vapor Lock Condition
  • PCM - Incorrect Misfire Condition/Flashing MIL
  • PCM - No Engine Restart/Rough Idle After Hot Soak
    • Overview
    • Repair Procedure
      • Overview
      • 2.7L Thermostat and Heater Supply Hose Modification (Revised)
  • PCM - No Engine Restart/Rough Idle After a Hot Soak.
  • Recall - Reprogram the PCM
    • Overview
    • Service Procedure
      • Overview
      • A. Reprogram the PCM
      • B. Install Authorized Software Update Label
      • C. Install the Authorized Modifications Label
      • D. Complete Proof of Correction Form For California Residents
    • Owner Letter
  • Powertrain Control Module - Multiple Concerns