Leak Detection Pump: Service and Repair

NOTE: The Leak Detection Pump is located under the right front headlamp behind the front fascia.


REMOVAL

Fig 11 Headlamp Attachment:

1. Remove screws from headlamp.
2. Pull headlamp away from vehicle.

Fig 12 Headlamp Electrical Connector Removal/Installation:

3. Disconnect electrical connector from headlamp.
4. Remove headlamp from vehicle.

Fig 13 Vacuum Line On LDP:

5. Disconnect vacuum line from Leak Detection Pump (LDP).
6. Remove hoses from evaporative canister.

Fig 14 Evaporative Canister Attachment Nuts:

7. Remove 3 nuts retaining evaporative canister to pump bracket.
8. Let evaporative canister set on lower fascia.

Fig 15 LDP Bracket Mounting Holes:

Fig 16 Front Upper Mounting Bolt:

Fig 17 Rear Upper Mounting Bolt:

9. Remove 4 bolts from LDP bracket.

Fig 18 LDP Pump And Filter:

10. Remove LDP and bracket from vehicle.
11. Remove evaporative canister.


INSTALLATION
1. Set evaporative canister on lower fascia.
2. Install LDP and bracket and tighten the 4 bolts.
3. Pull evaporative canister up into bracket and install the 3 nuts and tighten.
4. Install hoses onto evaporative canister and LDP pump.
5. Connect electrical connector onto headlamp.
6. Install headlamp and tighten 2 screws.
7. Use the DRB to test the LDP and system.