Cleaning and Inspection

1. Remove the upper left timing belt cover.
2. Inspect both sides of the timing belt drive & back. Replace belt if any of the following conditions exist.
^ Hardening of back rubber back side is glossy without resilience and leaves no indent when pressed with fingernail.
^ Cracks on rubber back.
^ Cracks or peeling of canvas.
^ Cracks on rib root.
^ Cracks on belt sides.
^ Missing teeth.





^ Abnormal wear of belt sides. The sides are normal if they are sharp as if cut by a knife.
3. If none of the above conditions are seen on the belt. the belt cover can be reinstalled.