Instrument Panel Top Cover Replacement

REMOVAL
1. Open glove box door.
2. Remove right end cap and remove screw at right end.

Top Cover:

3. Lift the right rear edge of top cover to disengage the clips along the rear edge. Proceeding from right to the left side. Do not use a nylon trim stick, to avoid potential damage.
4. Lift rear edge and slide top cover rearward disengaging clips and remove cover.

INSTALLATION
- For installation, reverse the above procedures. Ensure the two center clips are engaged first. Place thumb in VIN opening and pull towards pad to ensure VIN alignment. If a gap exist between the top cover and pad after installation check for a damaged clip. The clip must be removed and replaced.