Installation

1. Slide radiator and fan module down into position, seat the radiator assembly lower rubber isolators in the mount holes provided.
2. Attach air conditioning condenser to radiator, if equipped. Tighten mounting screws to 5 Nm (45 inch lbs.).
3. Connect engine block heater wire, if equipped.
4. Connect lower radiator hose and clamp. Connect automatic transmission hoses; tighten hose clamps to 2.5 Nm (22 inch lbs.).
5. Connect fan motor electrical connection.
6. Install upper radiator hose. Align hose so it does not interfere with the accessory drive belt or engine. Position hose clamp so it will not interfere with the hood liner.
7. Install upper radiator crossmember.
8. Connect negative cable from auxiliary jumper terminal.
9. Fill cooling system with coolant.
10. Operate engine until it reaches normal operating temperature. Check cooling system and automatic transmission for correct fluid levels.