Installation

PROCEDURE

CAUTION: Proper installation of wheel speed sensor cables is critical to continued system operation. Be sure that cables are installed in retainers. Failure to install cables in retainers as in this section may result in contact with moving parts and/or over extension of cables, resulting in an open circuit.

Rear Speed Sensor Head Attachment To Brake Support Plate:

1. Install speed sensor head into brake support plate.
2. Install wheel speed sensor attaching bolt. Tighten the speed sensor head attaching bolt to 8 Nm (75 inch lbs.)

Speed Sensor Cable Attachment To Rear Suspension:

3. Install speed sensor cable routing clips on the brake flex hose bracket and the bracket on the upper control arm. Install and securely tighten the routing clip attaching bolts.
4. Install connector end of speed sensor cable through hole in inner fender and into trunk of vehicle.

Rear Speed Sensor Cable Attachment To Body:

5. Install speed control sealing grommet into hole in inner fender. Install the sealing grommet retainer and attaching bolt on rear frame rail. Securely tighten retainer attaching bolt.
6. Install the tire and wheel assembly on vehicle.
7. Lower vehicle.

Rear Speed Sensor Cable Connection To Vehicle Wiring Harness:

8. Plug speed sensor cable connector into vehicle wiring harness. Install foam sleeve back over the speed sensor cable to vehicle wiring harness connection to prevent connector from rattling against body of vehicle.
9. Road test vehicle to ensure proper operation of the base and ABS systems.