Removal

PROCEDURE

Ground Cable Attachment At Strut Tower:

1. Remove the remote ground cable from the ground stud located on the left strut tower.

NOTE: Step 2 below is to be done to prevent the accidental grounding of the remote ground cable.

Correctly Isolated Remote Ground Cable:

2. Correctly isolate remote ground by installing the ground cable insulator on the strut tower ground stud as shown.

Stop Lamp Switch:

3. Remove the stop lamp switch from the brake pedal bracket. Stop lamp switch is removed using the following procedure. Depress and hold the brake pedal while rotating stop lamp switch in a counter-clockwise direction approximately 30°.

Input Rod Retaining Pin:

4. Remove the retaining clip from the brake pedal pin using following procedure. Position a small screwdriver between the center tang on the retaining clip and the brake pedal pin. Rotate blade of screwdriver enough so center tang on retaining clip can pass over end of brake pedal pin. Then pull retaining clip off brake pedal pin.
5. Remove the nut from the brake pedal pivot pin.
6. Remove bake pedal pivot pin from the brake pedal and pedal mounting bracket.
7. Remove brake pedal from mounting bracket.