Verification Test VER-3A - Charging System Verification

NOTE: Inspect the vehicle to ensure that all engine components are connected. Reassemble and reconnect components as necessary.


If The Powertrain Control Module Has Been Changed, Do The Following:
If the vehicle is equipped with a factory theft alarm, start the vehicle at least 20 times so that the alarm system may be activated when desired.
- Connect the DRB or equivalent Scantool to the PCM data link connector and erase the codes.

Ensure no other charging system problems remain by doing the following:
1. Start the engine.
2. Raise the engine speed to 2,000 rpm for at least 30 seconds.
3. Allow the engine to idle.
4. Turn the engine off.
5. Turn the ignition key on.
6. With the DRB or equivalent Scantool, read trouble code messages.
- If the repaired code has reset, or another one has set, check all pertinent Technical Service Bulletins and return to Trouble Code Test TC-1A if necessary.
- If there are no codes, the repair is now complete.