Front

REPLACEMENT
Only the case that a dust cover is damaged by mistake during servicing, replace it as follows:
1. Remove the dust cover.
2. Apply Mopar (R) Multi-mileage Lubricant Part No. 2525035 or equivalent.
3. Apply specified grease to the shown portion on the top of the lateral lower arm assembly dust cover.

CAUTION: Be careful not to let specified grease touch the ball joint thread and the knuckle joint (tapered portion). If it touchers, wipe it away.

4. Drive in the dust cover with special tool until it is fully seated.
5. Check the dust cover for cracks or damage by pushing it with finger.