Front

1. Remove approximately 1/3 of brake fluid from master cylinder.
2. Raise and support vehicle, then remove tire and wheel assembly.

Fig 1 MR34V & MR44V Dual Pin Floating Caliper Disc Brake Assembly:

3. Remove guide pin or lower slide pin, then lift caliper body upward and secure with wire.
4. Remove inner shims, anti-squeak shims, brake pad assemblies and pad clips from support mounting.
5. Press caliper piston into caliper bore with suitable tool.
6. Install upper and lower pad clips, pad assemblies, inner shims and anti-squeak shims into support mounting.
7. Lower caliper body, then install lockpin.
8. Depress brake pedal several times to seat pads, then inspect and replenish brake fluid as necessary.
9. Install wheel and tire assembly, then lower vehicle.