Wiper Motor
Testing and Inspection- Symptom Related Diagnostic Procedures
- Standard Wipers
- Intermittent Wiper System
- Important Information - Read First
- Motor Runs at High Speed, But Will Not Move at Low
- Motor Runs at Low Speed, But Will Not Move at High
- Motor Will Keep Running With Switch In "Off" Position
- Wipers Do Not Run When Washer Motor Is Engaged
- Wipers Run at Low Speed With Switch In High Speed Position
- Wipers Run Continuously\Switch In Intermittent Position
- Wipers Run;High Speed/Sw-Low;High Speed/Sw-Intermittent
- Component Tests and General Diagnostics
- Test 104A: Wiper Switch, Controller & Power Supply
- Test 104B: Wiper Switch Mode Sensor Circuit
- Test 104C: Wiper Motor Output Circuit, Test For Short
- Test 104D: Intermittent Wiper Motor Relay & Control Circuit
- Test 104E: Inoperative Low Speed Wiper Motor
- Test 104F: Open Power Supply Circuit to Wiper Switch
- Test 104G: Shorted Power Supply Circuit to Wiper Switch
- Test 105A: Wipers Inoperative In High Speed Mode
- Test 106A: Wipers Inoperative In Low Speed Mode
- Test 107A: Wipers Inoperative In Intermittent Mode
- Test 108A: Wipers Not Parking Properly
- Test 109A: Inoperative Wiper Wash Function
- Test 110A: Wipers Operate In High Speed Only
- Test 111A: Wipers Run Constantly With Ignition on
- Symptom Related Diagnostic Procedures
Locations
Service and Repair
Diagrams