Upper

1. Raise and support vehicle, then remove the front wheel and tire assembly.
2. Remove vehicle speed sensor cable routing bracket.
3. Remove cotter pin and castle nut from upper ball joint stud to steering knuckle attachment.
4. Remove upper ball joint stud from steering knuckle using puller tool No. C-3894-A, or equivalent, then position the steering outward toward rear of wheelwell.
5. Remove pinch bolt attaching shock clevis to shock.
6. Remove through bolt attaching shock to lower control arm.
7. Remove clevis from shock by carefully tapping clevis with soft brass drift off shock fluid reservoir.
8. Remove four bolts attaching upper control arm/shock absorber mounting bracket to shock tower.
9. Remove shock absorber and upper control arm mounting bracket as an assembly.
10. Reverse procedure to install.