Instrument Cluster / Carrier: Service and Repair

1. Disconnect battery ground cable.
2. Remove instrument panel left end cap.
3. Tilt steering column down to its lowest position.
4. Remove instrument panel center bezel by disengaging four clips.
5. Remove instrument cluster hood by doing the following:
a. Remove two screws adjacent radio.
b. Remove screw below HVAC control in center.
c. Remove screw at left end of panel.
d. Pull on hood to disengage eight clips.
6. Remove instrument cluster from panel. Pull cluster rearward to disconnect wire connectors from base panel.
7. Reverse procedure to install.