Master Cylinder Reservoir Replacement

REMOVAL
1. Clean master cylinder housing and brake fluid reservoir.
2. Remove reservoir cap and remove as much brake fluid as possible using suitable syringe or similar tool.

Removing Fluid Reservoir From Master Cylinder:

3. Rock reservoir from side to side while pulling upward to remove from master cylinder housing. Do not pry off using a tool as damage to reservoir may result.

4. Remove reservoir grommets from master cylinder housing.

INSTALLATION
1. Install new reservoir grommets in master cylinder housing.
2. Lubricate reservoir mounting area with fresh, clean brake fluid.
3. Install reservoir by pushing downward and rocking from side to side. Ensure reservoir is fully seated.