Master Cylinder Replacement

REMOVAL

1. Remove wiring harness connector from brake fluid level sensor mounted on fluid reservoir.
2. Disconnect the primary and secondary brake tubes from master cylinder housing. Install suitable plugs at all open brake tube outlets on master cylinder assembly.
3. Clean area where master cylinder attaches to power brake vacuum booster using a suitable brake cleaner.
4. On all models, remove nuts attaching master cylinder to power brake vacuum booster.
5. Slide master cylinder forward out of power brake vacuum booster.

INSTALLATION
1. Slide master cylinder assembly into power brake vacuum booster and position on mounting studs.
2. Install mounting nuts and torque to 250 inch lbs.
3. Connect brake tubes to master cylinder primary and secondary ports and torque tube nuts to 145 inch lbs.