1, 2 and 3 Digit Codes: 48

Name of Code:
48 - Torque Reduction (TRD) Link Communication Error

When Monitored:
Whenever the engine is running

Set Condition:
This code is set when the TCM sends multiple torque reduction messages to the PCM and the TCM does not receive a response from the PCM.

Theory of Operation:
During high torque shifts the TCM will send a message requesting that the PCM reduce engine power until the shift is completed. This message is sent from the TCM to the Powertrain Control Module (PCM) across the Torque Management Request Sense Circuit. The

PCM will acknowledge the TCM's request by sending a message across the CCD bus within a specific amount of time. The TRD Link communication is also tested periodically for operation whenever the engine is running and the vehicle is not moving with zero degrees throttle.

Transmission Effects:
Maximum throttle angle used by TCM will be 54 degrees. As a result a customer may complain about loss of performance or of short shifting when driving aggressively.

Possible Causes:
- Sticky Throttle Position Sensor (TPS)
- Wiring or Connector problems in the Torque Management Request Sense Circuit
- Defective PCM
- Defective TCM