Power Steering Pump: Service and Repair

1. Disconnect battery ground cable.
2. Loosen and remove power steering drive belt as outlined in the appropriate engine section.
3. Raise and support vehicle.
4. Drain power steering fluid from reservoir into a suitable container.
5. Loosen and remove power steering pressure hose from pump discharge fitting.
6. Loosen and remove bolts attaching pump to pump bracket through holes in pump drive pulley.
7. Remove pump and pulley as an assembly from the vehicle through bottom of engine compartment.
8. Reverse procedure to install, noting the following:
a. Install power steering drive belt as outlined in the appropriate engine section.
b. Bleed system as outlined under "Power Steering System, Bleed".