Instrument Cluster and Bezel

REMOVAL
To service any instrument cluster component, the instrument cluster must be removed from the instrument panel. Use the following procedure:

End Caps:

1. Remove the instrument panel left end cap. Instrument Panel End Covers - Left and Right Replacement
2. Remove the instrument panel headlamp bezel.
3. Remove the headlamp switch screws and move the switch to allow clearance for the instrument cluster removal.

Center Bezel:

4. Remove the instrument panel upper center bezel. Instrument Panel Center Upper Outlet Bezel
5. Tilt the steering column down into the lowest position.

Cluster Bezel:

6. Remove the instrument panel cluster bezel. LHS only, disconnect the message center wire connector. The message center lamps may be serviced at this time.
7. Remove the instrument cluster screws and disengage the upper latch.

CAUTION: Pull steering wheel down to gain access for instrument cluster removal.

8. Remove the instrument cluster from panel. The instrument panel wiring harness connectors are mounted directly to the rear panel. A force of approximately 9 kilograms (20 lbs.) will be required to disengage the cluster from the connectors.

INSTALLATION
- For installation, reverse the above procedures.