Rear

Refer to Brake Rotor/Specifications for runout specifications.

1. Raise and support vehicle, then remove wheels.
2. If applicable, ensure wheel bearings are properly adjusted.
3. Using suitable spacers install lug nuts or bolts, then tighten to specifications.
4. Mount a dial indicator to a convenient part of the vehicle (steering knuckle, tie rod, disc brake caliper housing).
5. Position dial indicator plunger so it contacts the disc at a point one inch from the outer edge.
6. Rotate the rotor and note the dial indicator readings. Perform this inspection on both inboard and outboard rotor faces.
7. If runout exceeds specifications, proceed as follows:
a. Position rotor on the hub, then inspect runout.
b. If runout still exceeds specifications, replace or machine the rotor.