Trough Guide Link Cover Removal

NOTE: The numbered call-outs in the following service procedure refer the numbered parts found in the exploded view diagram.

REMOVAL
1. Open sunroof to vent position.
2. Disengage push-in fasteners holding cover (8) to trough guide link (2).
3. Loosen bolt (26) from nut (55) holding trough guide link cover at rear.
4. Separate trough guide link cover from vehicle.

INSTALLATION
1. Place trough guide link cover in position on trough guide link.
2. Tighten bolt (26) and nut (55) to hold trough guide link cover at rear.
3. Engage push-in fasteners to hold cover to trough guide link.
4. Test sunroof operation.