RKE Transmitter Programming

1. Locate the Data Link Connector under the instrument panel to the right of the steering column.

2. Turn the ignition switch to the ON position.

Data Link Connector:

3. Ground pin 1 of the Data Link Connector. This is the programming line for the Remote Keyless Entry Module. The door locks will lock and unlock to indicate the receiver is ready to receive transmitter code. The trunk solenoid will not cycle at this time.

4. Press any button on the transmitter to set code. The locks will cycle to confirm programming. If there is a second transmitter, it must be set at this time. Press any button on the second transmitter and wait for the locks to cycle.

5. Disconnect the program line from ground. This returns the system to its normal operation mode.

6. Confirm proper system function by actuating the lock, unlock and trunk release buttons on the transmitter.