Sun Shade: Service and Repair

NOTE: The numbered call-outs in the following service procedure refer the numbered parts found in the exploded view diagram.

REMOVAL
1. Remove headlining.
2. Pull sunshade (6) rearward.
3. Pull sunshade (6) down at front.
4. Slide sunshade (6) forward through cut-out in sunroof module tracks (10).

CAUTION: Do not crease the sunshade when removing or installing.

5. Separate sunshade (6) from vehicle.

INSTALLATION
1. Position rear of sunshade (6) into cut-out in sunroof module tracks (10) and align in tracks.
2. Slide sunshade rearward.
3. Slide sunshade forward, allowing sunshade (6) to move upward into sunroof module tracks (10).
4. Test sunshade operation by sliding it back and forth a few times. Operation should be smooth and consistent.
5. Install headlining.