Compressor/Pump: Service and Repair

Fig. 29 Automatic Air Load Leveling System:

REMOVAL

1. Disconnect battery negative cable and raise vehicle.
2. Remove compressor cover, air hose and electrical connectors.
3. Remove compressor mounting bracket screws, then lower assembly from vehicle.
4. Remove mounting bracket screws, then mounting bracket from compressor.

INSTALLATION

1. Reverse procedures to install, torquing all screws to 70 lb-in.
2. Refer to Steering and Suspension/Suspension/Electronic Level Control/Compressor/Pump (Level Control)/Testing and Inspection/Procedures while checking operation if necessary to make adjustments.