Engine - Starts and Immediately Stalls

91chrysler02

SUBJECT: Start and Stall - Vehicles Not Equipped With Vehicle Theft Alarm (VTA)


NO.: 14-01-91


GROUP: FUEL


DATE: Feb. 11, 1991


MODELS:


1991 (AC) DYNASTY/NEW YORKER SALON (AY) IMPERIAL/NEW YORKER FIFTH AVENUE

SYMPTOM/CONDITION:


The vehicle cranks, starts and immediately stalls. This may be caused by engine controllers, on vehicles not equipped with Vehicle Theft Alarm (VTA), invoking a VTA engine shut down.

DIAGNOSIS:


With a DRB II connected to the engine diagnostic connector, select "FUEL/IGNITION" under "ENGINE". Select "STATE DISPLAY (3)", "MONITORS (4)", and then "NO START (6)". The display will read "VTA FUEL". Crank the engine. If "VTA KILL" is displayed, replace the SBEC.

PARTS REQUIRED:

1 Single Board Engine Controller (SBEC)

2.5L Federal PN 4672482

3.3L Federal PN 4686442

3.3L California PN 4686444

REPAIR PROCEDURE:

This procedure involves replacement of the SBEC with a revised SBEC.

1. Replace the SBEC with the appropriate part from the list above.

Figure 1:

2. Type the required information on the Authorized Modification Label, as illustrated in Figure 1, and attached near the VECI label.


*INSERT PART NUMBER USED

POLICY: Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:

Labor Operation No. 08-19-90-97 . . . . . . . . . . . . . . . 0.4 Hrs.

FAILURE CODE: AM - Authorized Modification