Erasing Codes 23-28

Code 23-28 may be erased from the computer's memory after repairs have been made. If these codes are intermittent, they will remain in the computers memory for up to 60 ignition switch ON/OFF cycles.

To erase codes 23-28:
1. Run the diagnostic test.
2. Press the panel button to access all failure codes. The display will flash alternating zeros.
3. Within 5 seconds you must press the A/C button.
4. The display will now flash alternating E's. This indicates erase mode.
- Press any button within 5 seconds and erase mode will be aborted.