Parking Brake Lever: Service and Repair

REMOVAL
1. Remove ash receiver or courtesy light from rear of console.
2. Remove carpet from sides of console.
3. Remove parking brake trim cover from side of console (pulls off).
4. Load and lockout parking brake self adjuster. Disconnect rear cables from equalizer bracket.
5. Remove three hold down nuts and remove hand lever assembly through opening created by removeing console trim cover. Passenger seat may have to be removed. Also, if metal tab at bottom of console prevents removal of brake assembly, then bend out of the way. (Bend back after R&R of hand brake).

INSTALLATION
1. Install hand lever assembly through side opening in console and bolt in place.
2. Connect rear parking brake cables to equalizer.
3. Adjust parking brake.
4. Install console trim cover, carpet, passenger seat, and ash receiver or courtesy light.