Ignition Coil: Service and Repair

Coil Location And Connector Terminals:

REMOVAL



1. Remove air cleaner assembly.
2. Disconnect the coil to distributor ignition cable.
3. Disconnect the wiring harness connector from the coil.
4. Remove the screws holding the coil in place and remove coil.


INSTALLATION


1. Loose install the ignition coil to the intake manifold. Torque the intake manifold fastener to 115 lb.in. (13 Nm). Torque ignition coil bracket fasteners to 94 lb.in. (10 Nm).
2. Connect the wiring harness connector.
3. Connect the coil to distributor ignition cable.
4. Install the air cleaner assembly. Torque the air the cleaner fasteners to 225 lb.in. (25 Nm).