Wipers Fail to Stop Test

Fig. 1 Two-speed Motor Terminal Locations:

Fig. 2 Intermittent Wiper Motor Terminal Locations:

Fig. 3 Wiper Motor Terminal Location:

1. On models with non-concealed wipers, remove wire connector and connect jumper wire from motor terminal L to terminal P2. Connect a second jumper wire from terminal P1 to battery. If motor runs to park position and stops, wiper switch is defective. If motor continues to operate and does not park, replace gearbox assembly.
2. On models with concealed wipers, disconnect wire connector and connect a jumper wire from terminal P1 to battery. Connect a second jumper wire from terminal L to ground. If motor runs to park position and stops, wiper switch is defective. If motor continues to operate, replace gearbox assembly.