Universal Joint & Roller

DISASSEMBLY

1. Mark relationship of shafts to insure proper alignment during assembly. Apply penetrating oil to bushing, then remove snap rings.
2. Support yoke in vise, then position 1 1/8 inch socket over bushing on top of yoke.
3. Strike socket with a suitable hammer until bushing moves up out of yoke into socket.
4. Turn assembly in vise and remove remaining bushings in same manner.

ASSEMBLY

1. Hold cross in position between yoke ears with one hand and start one bushing assembly into yoke with other hand.
2. Hammer bushing assembly into yoke, then install snap ring.
3. Install remaining bushing assemblies in same manner.