Ride Height Sensor: Service and Repair

1. Disconnect battery ground cable.
2. Raise and support vehicle, then remove wheel and tire.
3. Disconnect height sensor electrical connector located on right rear frame rail.
4. Remove shock absorber as follows:
a. Support rear axle.
b. Remove upper and lower shock absorber fasteners, then the shock absorber.
5. Reverse procedure to install, noting the following:
a. Torque upper shock absorber fasteners to 45 lb-ft.
b. Route height sensor wire through retaining clips, then secure to fuel filler tub e with a tie strap.
c. With suspension supporting vehicle, torque lower shock absorber fastener to 40 lb-ft.