Pump/Motor Service

Fig. 3 - Pump/Motor Mounting:

REMOVAL

(1) De-pressurize hydraulic accumulator by pumping brake pedal a minimum of 40 times, as described in this section.

WARNING: FAILURE TO DE-PRESSURIZE HYDRAULIC ACCUMULATOR, PRIOR TO PERFORMING THIS OPERATION, MAY RESULT IN PERSONAL INJURY AND/OR DAMAGE TO PAINTED SURFACES.

(2) Remove fresh air intake ducts from engine induction system.

(3) Disconnect electrical connectors (including the one on the pump/motor) which runs across engine compartment in the vicinity of the pump/motor high and low pressure hoses.

(4) Disconnect high and low pressure hoses from hydraulic assembly. Cap spigot on reservoir.

(5) Disconnect pump/motor electrical connector from engine
mount.

(6) Remove pump heat shield bolt from front of pump bracket.
(7) Remove front heat shield.

(8) Lift pump/motor assembly from bracket and remove assembly from the car.

INSTALLATION

(1) Install pump/motor assembly in reverse order of removal.