Late Production

1. Raise and support vehicle, then remove wheel and tire assembly.
2. Remove sensor assembly grommet from underbody and pull harness through hole in underbody.
3. Unplug connector from harness, then remove sensor grommet bracket screw from body hose bracket, just forward of trailing arm bushing.
4. Remove sensor assembly clip, located on inboard side of trailing arm.
5. Remove rear sensor wire fastener from rear brake hose bracket, then the outboard sensor assembly retainer nut.
6. Remove sensor head screw, then remove sensor head from adapter assembly. If sensor has seized, due to corrosion. Do not use pliers on sensor head. Use a hammer and a punch and tap edge of sensor ear, rocking sensor side to side until free.
7. Reverse procedure to install, coat speed sensor with High Temperature Multi-Purpose grease before installing into steering knuckle and torque screw to 5 lb-ft