Late Production

1. Raise and support vehicle, then remove wheel and tire assembly.
2. Remove screw from clip that attaches sensor assembly to fender shield.
3. Pull sensor assembly grommet from fender shield, then unplug sensor connector from harness.
4. Remove retainer clip from bracket on strut damper, then the three sensor assembly grommets from retainer brackets.
5. Remove sensor head screw, then remove sensor head from steering knuckle. If sensor has seized, due to corrosion. Do not use pliers on sensor head. Use a hammer and a punch and tap edge of sensor ear, rocking sensor side to side until free.
6. Reverse procedure to install, coat speed sensor with High Temperature Multi-Purpose grease before installing into steering knuckle. Proper installation of wheel speed sensor cables is critical for continued system operation. Failure to install cables in retainers, may result in contact with moving parts, resulting in an open circuit.